Application and Futuremark Performance

What we're essentially trying to gauge here is how an Ivy Bridge processor with reduced overclocking headroom compares to a Sandy Bridge chip with lower IPC and higher clocks. In the process, we can also see how both of them compare to chips with lower IPC and extra cores (specifically Gulftown and Sandy Bridge-E).

Futuremark PCMark 7

Futuremark PCMark Vantage

Out of the gate the PCMarks are both responding well, but I suspect that may also be due to the Intel SSD employed in this Erebus GT. It may still be using SandForce's controller, but it's Intel's firmware. Whatever the case, for general use the new Erebus GT screams through PCMarks, delivering a 7% increase in PCMark 7 and 12% in Vantage compared to the previous model.

3D Rendering - CINEBENCH R10

3D Rendering - CINEBENCH R10

3D Rendering - CINEBENCH R11.5

Video Encoding - x264

Video Encoding - x264

Looking at the CPU-dependent benchmarks may or may not be troubling, depending on your perspective. From the looks of things, Ivy Bridge's improved IPC is almost entirely mitigated by its reduced overclocking headroom. The IVB Erebus GT is a scant 2% faster in most of our CPU tests, with the SNB variant actually taking a slight 1% lead in Cinebench 11.5. What's interesting is that on the CPU side, even overclocking and increased IPC still doesn't bridge the gap between Intel's quad cores and their hexacores; the i7-990X still runs wild in any task that can take advantage of the extra cores.

Futuremark 3DMark 11

Futuremark 3DMark Vantage

Futuremark 3DMark06

What can we take away from the 3DMark results? 3DMark06 is always going to be CPU-limited (and probably should be deprecated at this point), but in 3DMark Vantage's older workload we see a pair of GTX 680s essentially equaling the performance of two GTX 590s. That's two current generation GPUs hitting stride with four of last generation's. When you get to 3DMark11, the GTX 680s just run away with it. This is important, remember it, because it's going to come up again when we get to power consumption.

Re-Introducing the iBuyPower Erebus GT Gaming Performance
Comments Locked


View All Comments

  • JarredWalton - Friday, April 27, 2012 - link

    Based on previous pricing by iBUYPOWER, I'd guess they'll end up charging around $3000. However, we can't really print that since it's just a guess. :-p
  • awall13 - Friday, April 27, 2012 - link

    Would be nice to see noise measurements for this water cooled setup. Seems to me that it would be an important consideration for a potential buyer compared to building their own (more likely air-cooled) setup.
  • ewood - Friday, April 27, 2012 - link

    Normally I would overlook this little slip up but it is the third time I have heard an anandtech article refer to Lynnfield as a tick when in fact it is a tock. It did not use a new fab process and it did employ a new architecture. Lynnfield was a tock. Get it right, you're a hardware site.
  • JarredWalton - Friday, April 27, 2012 - link

    Sorry, you're right. I screwed up and looked at Lynnfield. The article has been adjusted, but in my above comment, if you just replace "Lynnfield" with "Clarkdale" not a whole lot changes. Clarkdale was very underwhelming, and Gulftown is highly specialized. I never actually ran either one other than seeing a hex-core Gulftown stuffed into a Clevo X7200. :-\

    The problem is that Intel made comparisons very messy with Westmere. On the desktop we had Clarkdale (dual-core plus IGP) and Gulftown (hex-core and no IGP). On laptops we had Arrandale (basically just mobile Clarkdale). There were no mainstream quad-core Westmere parts, so you had mainstream dual-core or high-end hex-core and never the twain shall meet.

    Anyway, don't feel too superior for catching the error -- try writing about technology and code names for a few years and I can pretty much guarantee you'll make some mistakes. Heck, just read the tech junky posts in hardware forums and even the best people make mistakes.
  • JarredWalton - Friday, April 27, 2012 - link

    And yes, I know that Clarkdale's IGP was actually 45nm on package.
  • web2dot0 - Friday, April 27, 2012 - link

    Isn't there something fundamentally wrong with people using 1200W of power to play computer games? Considering that there is a power shortage all over California, it's pretty abusive to hoar all that juice when there are better ways to spent it.

    Not trying to be judgemental or anything, but there should be regulation on energy consumption for computers that are not work-related. No different than emission standards for cars and such.
  • UltimateKitchenUtensil - Saturday, April 28, 2012 - link

    1200 W is just the power supply's capacity. If the components draw less than that (in this case, much less than that), the supply will only give them what they need. And it will do it very efficiently, since the AX-1200 is 80+ Gold.

    In this case, even though the power supply is rated 1200 W, the system, under load, only consumes 471 W of power. Some of it is wasted, but over 80% is used by the system.
  • web2dot0 - Saturday, April 28, 2012 - link

    I'm sure having a 80+ Gold PSU is great, but you are still using alot of power. I'm guessing if you plan to have a SLI config, you are going to OC the CPU, and everything else.

    A regular PC consumes < 150W, this PC is using 471W.

    I'm also guessing that people who buys these bad boys aren't exactly casual gamers, so these PCs will be under load way more often than an average PC.

    Just saying ....
  • buzznut - Saturday, April 28, 2012 - link

    Its funny, AMD comes out with a product that equals its previous efforts and its a major fail. Why do we find it so easy to forgive Intel?

    "I feel like a lot of us were hoping for either a bigger performance improvement or better overclocking headroom due to the new process, but what we have instead is a chip that, when pushed to its conventional limits, is essentially still only the equal of its predecessor in terms of performance."

    And doesn't overclock as well. Aren't you glad you ran out and bought that Z77 board?

    Obviously it has a little to do with power and efficiency. At least BD is much more capable with respect to overclocking. I am very underwhelmed.

    Which is what confuses me. Ivy Bridge has been overhyped as much as bulldozer was. People really should be asking, "what happened?"
  • Dustin Sklavos - Saturday, April 28, 2012 - link

    Ivy Bridge is still directly superior to Sandy Bridge in almost every way BUT overclocking headroom. I'm underwhelmed by Ivy Bridge, but it's much more efficient in terms of power consumption than Sandy Bridge. Before overclocking, you get slightly better performance for much less power.

    Bulldozer was in many ways a step BACK from Deneb and Thuban. The FX-8150 should always have at least equalled the Phenom II X6 1100T, but in certain cases it was actually slower.

    That, and everyone wanted and needed Bulldozer to do well for AMD's sake, the sake of the market, the sake of the community. Nobody was really looking at Sandy Bridge and going "boy, if Intel could make this thing faster we'd all be better off."

Log in

Don't have an account? Sign up now